LeCroy 9410 - Page 98

System Commands
|
|
QUERY SYNTAX
Response format
EXAMPLE (GPIB)
RELATED COMMANDS
<device> := {FP5301, PM8151,0HP7470A, HP7550A, HPQJ,
HPTJ, HPLJ, EPSON}
<port> := {GPIB, RS}
<plot_speed> := {N, L} for plotters only
<density> := {SINGLE, DOUBLE, QUADRUPLE,
HIGH_SPEED, HIGH_RESOLUTION,
ONE TO ONE, TWO TO ONE,CRT}
for printers only
<plot_pens> := 1 to 8
<page_feed> := {ON, OFF}
<paper size> := {A5, A4, A3, NS}
<grid_square> := 0.0 to 99.9 MM
<lower left X>:= -999 to 999 MM)t for non-standard
1
paper size only
<lower left Y>:= -999 to 999 MM/
Note: For these three parameter values the suffix is optional.
The suffix M is assumed.
HardCopy_SetUp?
HardCopy_SetUp DEV,<device>,PORT,<port>,
SPEED,<plot_speed>, DENS,<print_density>,PENS,<plot__pens>,
PFEED,<page_feed>, PSIZE,<paper_size>,GRID,<grid_square>,
LLX,<lower_left_X>,LLY,<lower left Y>
This example selects a HP 7550A plotter to be driven by the GPIB
port.
CMD$="HCSU PORT,GPIB, DEV, HP7550A"
CALL IBWRT(SCOPE%,CMD$)
HARDCOPY_TRANSMIT, SCREEN_DUMP
I
I
II
II
II
I
I
II
II
II
I
II
II
II
92
II
II