LEGRAND DX2 Series - Configuring DX2-Cc2 S Normal State

2) Separate the terminal module from the sensor box.
3) Aer connecng detectors/switches to the terminal module, plug the terminal module back into the
sensor box, and then ghten the screws at two sides of the terminal module.
Conguring DX2-CC2's Normal State
Before using DX2-CC2 for detecon, select the normal state of DX2‑CC2 via the soware applicaon of
the supported managing device where this DX2‑CC2 is being connected.
24