Page 63
301 Fulling Mill Road, Suite G ©Copyright 2015 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800) 321-2343 www.legrand.us
When you select the device, you will see a screen reminding you to review the manufacturer’s
instructions for device removal. Then press the “Remove” button.
NOTE: Once you select the Category list, you will be presented with a list all devices
currently installed on the system pertaining to that Category. At the top of this list is the
Device Adapter (software). If you select and Remove the device adaptor all devices under
the list will be removed from the system, along with the Adapter software!!
There are two methods to reinstall an Adapter that has been removed,
1) Power cycle the system, then wait 2-5 minutes for the adapter to download again.
2) From the main menu select “Device Assistant”, “Add Device” and “Manual Addition”.
Then pick the device adapter (without having to power cycle). Using this method will
require you to perform this step two times in order to discover devices (once to install the
adapter and again to install the devices).
NOTE: Some devices can only be removed by removing the Device Adapter. These
devices include:
1. Security System Zones
2. Partitions
3. Audio Zones
4. Thermostat Sensors
NOTE: To remove Z-Wave devices, the pairing button on the device itself must be pressed
after the “Remove Device” selection has been made in the WiFi to Z-Wave adapter.
To Next Page
Loading...
Need help?
General
