Page 56
301 Fulling Mill Road, Suite G ©Copyright 2015 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800) 321-2343 www.legrand.us
Appendix A: FAQ
1. How do I return a Bridge to Factory Default?
Press the “Connect” button 10 times. LED’s on the Bridge should begin flashing then change
to Factory Default after 10 seconds.
Factory Default is signified by the Top LED appearing solid, middle LED blinking slowly, and
bottom LED off.
If the Bridge does not appear to Factory Default, press the recessed “Reset” button on the
front of the Bridge for 2 seconds with a paper clip. If the Bridge still does not appear to
Factory Default, repeat steps above or call Legrand Technical Support for further assistance.
NOTE: Pressing the recessed Reset button on the front of the Bridge for 2 seconds
with a paper clip power cycles the Bridge.
To Next Page
Loading...
Need help?
General
