Page 57
301 Fulling Mill Road, Suite G ©Copyright 2015 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800) 321-2343 www.legrand.us
2. Can I commission the Intuity system from a tablet?
Yes, however, the recommended method is to use a Notebook, Tablet, or Laptop with a
Chrome/Safari browser.
3. Why can’t I see cameras from the browser?
This capability will be available in a future software update. Today Cameras can be named
and assigned to a room from the browser. We recommend launching a separate browser
during commissioning to view the Cameras if needed. Cameras can also be viewed from the
Intuity App.
4. How does the user view their cameras?
Homeowners will view their Cameras from the Intuity App. For remote viewing, refer to
Section 7.2.1 of this manual.
5. How do I change a Security Subsystem Zone Name?
Zones should be named in the Security subsystem prior to commissioning Intuity. Security
Zone names are downloaded from the Alarm Panel to the Intuity system during
commissioning of the Security subsystem. Refer to the Security system installer for
assistance.
6. How do I set up Quick Arm?
Quick Arm must first be setup on the Security subsystem by the security installer. Refer to
Section 7.1 of this manual for changing Quick Arm settings inside of Intuity.
7. How do I change an Audio Zone name?
The Legrand Digital Audio subsystem should be commissioned and Zones named before
commissioning the Intuity system. Audio Zone names are downloaded from the Legrand
Digital Audio subsystem to Intuity during audio commissioning. To name audio Zones refer to
Legrand Digital Audio user documentation.
8. How do I Reset the Intuity Controller back to factory default?
We recommend Intuity system installers only perform a factory reset when instructed by
Legrand Technical Support.
9. How do I Reboot the Intuity Controller?
We recommend contacting Legrand Technical Support if it is felt a reboot should be
performed. The system can be rebooted via a power cycle or via the web browser (refer to
Appendix B4/7). Please allow at least 2 minutes after a system reboot is performed for the
system to load settings.
To Next Page
Loading...
Need help?
General
