Leica DM2000, Safety Directions
12
1.8 ICES-003 Statement, Applicable in Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
WARNING
This Class (A) digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe (A) est conforme à la norme NMB-003 du Canada.
Exposure to Radio
Frequency (RF)
Signals
The wireless device is a radio transmitter and receiver. It is designed and manufactured
not to exceed the emission limit for exposure to radio frequency (RF) energy set by
the OET Bulletin 65 Supplement C / Ministry of Health (Canada), Safety Code 6. These
limits are part of comprehensive guidelines and established permitted levels of RF
energy for the general population. These guidelines are based on the safety standards
previously set by international standard bodies. These standards include a substantial
safety margin designed to assure the safety of all persons, regardless of age and
health.
This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
This device has been shown to be capable of compliance for localized specific absorp-
tion rate (SAR) for uncontrolled environment / general public exposure limits specific
in ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement
procedures specified in IEEE Std. 1528-2003.
IC Canadian Compli-
ance
This radio transmitter has been approved by Industry Canada to operate with the
antenna types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p) is not more than that necessary for successful communication.This device
complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:(1) This device may not cause
interference. (2) This device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec
les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et
l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans
cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.Conformément à la réglementation d'Indus-
trie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type
et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'étab-
lissement d'une communication satisfaisante.Le présent appareil est conforme aux
CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploita-