EN
188
Basic camera settings
ENERGY-SAVING SETTINGS
In order to increase battery life, you can have the monitor and/or
camera switched off automatically after a specified period of time.
Setting the function
1. In the menu's
SETUP section, select Power Saving,
2. in the sub-menu,
Auto Power Off or Auto LCD Off, and
3. the desired settings in the respective submenus.
If these functions are active, the camera switches to energy-saving
standby mode or the monitor switches off after the selected time.
Note:
Even if the camera is in standby mode, it can be activated again at
any time by pressing the shutter release button or by turning it off
and back on with the main switch.
MONITOR/VIEWFINDER SETTINGS
Switching between monitor and viewfinder
The displays are the same, regardless of whether they appear on
the monitor or in the viewfinder.
You can determine whether the displays appear on the monitor
only, or automatically switch between monitor and viewfinder,
based on the proximity sensor in the eyepiece (default setting).
Setting the function
Press the button immediately to the right of the viewfinder.
Additionally, you can also change the sensitivity of the sensor. In
order to ensure that the switch happens reliably, eyeglass wearers
should select
Auto - High Sens., whereas users without glasses
can leave it set to
Auto - Low Sens..
1. In the menu's
SETUP section, select Display Settings,
2. in the sub-menu
Eye Sensor Sensitivity, and
3. the desired setting in the corresponding submenu.
Monitor brightness
The brightness of the monitor display can be changed for optimized
recognition and adjustment to different lighting conditions.
Setting the function
1. In the menu's
SETUP section, select Display Settings,
2. in the sub-menu
LCD Brightness, and
3. the desired setting in the corresponding submenu.
SL_EN.indd 188 16.09.2015 15:04:27
To Next Page
