1.4 Optional Extras Lely Splendimo 240 MCR
1.4.1 Wear Plates
Wear plates can be installed on the bottom of the skids to reduce wear of the
skids. The wear plates are available in thicknesses of 4 mm or 8 mm.
1. Wear plate - 2. Topping skid
Figure 2. Wear Plate and Topping Skid
1.4.2 Topping Skids
Topping skids can be installed on the bottom of the skids to raise the mowing
height approximately 3 cm. This is used for topping or when the mower is used
on rough ground, and reduces damage to the cutter bar by stones and other
debris.
If topping skids are installed, position 2 or 3 of the parking jack must be used
(fig. 6, page 3-3).
1.4.3 Agitators
Agitators can be installed on the mower discs to improve the crop flow across
the cutter bar in certain circumstances.
Figure 3. Agitator
1-4 Introduction
M-H025.1011EN
To Next Page
Loading...