5.2.8 Grease the Bearings Block of the Conditioner Rollers
• Requirements:
•
Biodegradable grease (Total Biomultis SEP2 or equivalent)
• Grease pump
1. On the left side of the Splendimo:
1. Remove the inspection hole cover of the V-belt housing.
2. Use the grease pump to grease the bearings of the top and bottom
conditioner roller.
3. Install the inspection hole cover.
2. On the right side of the Splendimo:
1. Remove the tarp from the transmission housing.
2. Remove the transmission housing.
3. Use the grease pump to grease the bearings of the top conditioner
roller.
4. Install the transmission housing.
5. Install the tarp on the transmission housing.
Figure 24. Grease the Bearing Blocks of the Conditioner Rollers
Maintenance 5-9
M-H025.1011EN
To Next Page
Loading...