1.2 Roller Conditioner Unit
The roller conditioner unit is used to condition leafy crops.
The
position of the rollers can be adjusted to give more clearance between the
rollers. This in combination with the tension between rollers determines the
intensity of the conditioning
The bottom roller is driven by a v-belt and drives the top roller by a gear
assembly. These gears are connected by movable arms to let the rollers move
separately from each other. This enables you to adjust to the crop flow or to
allow a larger crop volume to pass. The wide profile of the rollers give a firm
grip on the crop.
An optional drive pulley for the conditioner rollers changes the speed.
1.3 Hydraulic System
The hydraulic system raises and lowers the cutter bar.
When the hydraulic system is set to the floating position the cutter bar can
closely follow ground contours.
The ground-pressure relief system makes sure the cutter bar follows the
ground contours without damaging the crop and transfers some of the
Splendimo weight to the tractor.
It can be adjusted by regulating the pressure of the hydropneumatic spring
system.
Introduction 1-3
M-H025.1011EN
To Next Page
Loading...