20. Tighten the M30 (16) nut until the securing plate (13) can be installed.
21.
Install the securing plate.
1.Mower knive - 2. Mower disc - 3. Pressure piece - 4. Castellated nut - 5.Hat - 6. Hat - 7.
Drive
shaft - 8. Centring ring - 9. Intermediate spacer - 10. Mower element - 11. Securing plug
- 12. Locking ring - 13. Securing plate - 14. Washer - 15. Bolt M10 x20 - 16. M30 nut - 17.
Ring - 18. Bolt - 19. End plate - 20. Connecting rod
Figure 32. Exploded View of the Cutter Bar
Figure 33. Direction of Rotation of Mower Elements
Figure 34. Torque load Nut M30
Maintenance 5-21
M-H025.1011EN
To Next Page
Loading...
