6. If an electrically controlled hydraulic system is installed:
1.
Disconnect the electrical power supply for the control box from
the tractor.
2. Remove the control box from the tractor cab.
7. Disconnect the three hydraulic hoses from the tractor hydraulic system.
8. Install the three dust caps on the three hydraulic hoses.
9. Attach the three hydraulic hoses to the support on the headstock.
10. Disconnect the Splendimo primary PTO-shaft from the tractor PTO.
11. Connect the Splendimo primary PTO-shaft to the parking chain.
12. If stabilization chains (or rods) are used:
• Disconnect the stabilization chains (or rods) from the lower arms of
the tractor.
13. Disconnect the top link from the headstock.
14. Disconnect the two lower arms from the linkage pins on the headstock.
15. If necessary remove any spacers installed on the linkage pins.
16. Remove the ram-lock operating cord from the tractor cab.
17. Remove the tractor from the area.
Figure 8. Parking Positions
3.3 Move the Splendimo to the Transport Position
Make sure there are no persons in the area when you move the Splendimo
to the transport position.
Make sure the front axle weight of the tractor is sufficient (use front
weights if necessary) and that you do not exceed the rear axle weight
when the Splendimo is in the transport position.
Make sure the PTO shaft does not turn when the Splendimo is in the
transport position.
Use all lights and warning signals as defined by your local road traffic
regulations.
WARNING
WARNING
WARNING
CAUTION
Operation 3-3
M-H021.1004EN
To Next Page
Loading...