507343-01
Page 18
Partial iComfort
®
System — Adjusting Humidification Settings (Non-Communicating
Outdoor Unit)
SYSTEM DEVICES SCREEN — HUMIDIFICATION CONTROL MODE
System Devices
edit
about
To adjust a setting, highlight it,
then press Edit
System
resetAll
next
back
1a
1b
edit
reset
Humidification Control Mode
current value:
back
Basic
Pre-adjustment REQUIREMENTS:
1st, the required devices (outdoor unit and humidifier) has
been installed (see page 6).
2nd, you pressed next at the Add or Remove... screen (see
page 6).
Configure the device as follows:
1. In the system devices list, use the arrows (1a) to highlight
System. Press edit (1b).
2. In the System list, use the arrows (2a) to highlight
Humidification Control Mode. The current value defaults to
Basic mode. Press edit (2b).
3. Touch one of the radio buttons (3a) to select the mode of
humidification control; press save (3b). (After saving,
check that the current value now shows the new
selection).
4. Press the back button to return to Adjust a setting...
screen.
NOTE - If the defaults for the settings shown in red, you are not
required to make any changes, but you must go into the edit tool,
and press save (5b). When all red text is gone, the back button
will appear; press it to return to the Adjust a setting.. screen.
Display Only Basic
Precision Basic Dew Point Control
Precision Dew Point
Select one
Humidification Control Mode
cancelsave
3b
3a
2a
2b
System
Air Conditioner
Furnace
Thermostat
Power (120VAC) Humidifier
System
2nd Stage Differential
Staged Delay Timers
2nd Stage Delay
De-humidification Control Mo
Humidification Control Mode
Figure 14. Adjust a Non-Communicating Device Setting — Humidification
To Next Page
Loading...
