507343-01
Page 6
NON-COMMUNICATING EQUIPMENT — ADDING A HUMIDIFIER
To add (or remove) a humidifier:
1. Press the yes button on this screen (see 1).
2. In the “non-communicating device list” screen, use the
arrows (2a) to highlight Humidifier (note the current
value, Not Installed) and press edit (2b).
3. Touch one of the radio buttons (3a) to select humidific
ation equipment type. Options available are dependent
on indoor unit model.
4. The previous screen returns, but the current value
now shows your selection (4a). Press the back (4b)
button.
5. The Add or Remove... screen reappears with your
addition shown in the system devices list (5a). At this
point, you may add more equipment (press yes) or if
finished, press the next (5b) button to advance to the
Adjust a setting... screen (see page 18).
NOTE - Adding humidity regulating non-communicating de
vices may be a 2-step procedure:
1st, the device must be installed and wired. After the hu
midifier is installed, the setting under the System mode
Humidification Control Mode defaults to Basic).
2nd, (if you want another mode, i.e. Precision, Basic Dew
Point, or Precision Dew Point, the device requires further
configuration (see page 18).
nextback
Before adding a humidifier, be sure that:
The humidifier is wired to the furnace or air handler
control as shown on the optional accessories wiring
diagram.
The entire system is wired, powered up, and the
thermostat has detected the system's installed com
municating devices, and you are at the Add or Re
move Non-communicating equipment? screen.
system devices
System
Heat Pump
Furnace
Thermostat
yes
edit
to add/remove/adjust a device,
select it, then press edit
Not Installed
current value:
non-communicating device list
2a
Humidifier
Dehumidifier
Electronic Air Cleaner
1
Add or Remove Non-
communicating
equipment?
Select one
Humidifier
cancelsave
3b
2b
Not Installed Humidification
edit
to add/remove/adjust a device,
select it, then press edit
xxxxxxxxxxxxxxxxxxxxxxxr
current value:
non-communicating device list
Humidifier
Dehumidifier
Electronic Air Cleaner
back
5a
system devices
9:39 am Aug 15, 2012
nextback
yes
Add or Remove Non-
communicating
equipment?
4a
4b
System
Heat Pump
Furnace
Thermostat
Bypass (24VAC) Humidifier
5b
3a
edit
to add/remove/adjust a device,
select it, then press edit
Not Installed
current value:
non-communicating device list
2a
Humidifier
Dehumidifier
Electronic Air Cleaner
Select one
Humidifier
cancelsave
3b
2b
Not Installed Bypass (24VAC) Humidifier
3a
edit
to add/remove/adjust a device,
select it, then press edit
Not Installed
current value:
non-communicating device list
2a
Humidifier
Dehumidifier
Electronic Air Cleaner
Select one
Humidifier
cancelsave
3b
2b
Not Installed Bypass (24VAC Humidifier
3a
Power (120VAC Humidifier Bypass and Power Humidifier
Options available
for EL296 and
SL280
Options available
for SLP98
Options
available for
CBX32MV and
CBX40UHV
Figure 7. Add Non-Communicating Device — Humidifier
To Next Page
Loading...
