iComfort Wi-Fi
®
7-Day Programmable Communicating Thermostat
Page 27
2. Select the access point that has already been establish
and connected too. There are two options to select from
which are connect and AP info. Select AP Info and verify
the RSSI strength. If the signal is anywhere between -1 to
-69, then the signal strength is sufficient. If outside this
range, the either locate the router closer to the thermostat
or add a repeater.
ACCESS POINT INFO
Detailed information for the access point
MAC=
WSTATE=CONN.
BSSID=68
RSSI= -46
IP addr=
Figure 31. Verifying Signal Strength
Registering the iComfort Wi-Fi
®
Thermostat
REGISTRATION FOR ONLINE ACCESS
1. From the WI-FI SETTINGS screen, press either the
thermostat not registered icon or the connection
status icon and select the server icon.
WI-FI SETTINGS
connectio
n status
thermostat
not
registered
AP3
connected
press to change
network settings
press to enable /
disable Wi-Fi
press to change
thermostat
registration
press to toggle
off / auto
Wi-Fi
enabled
2. Enter homeowner email address and system description
and press the register button.
register
enter your email
Register with iComfort Wi-Fi thermostat to enable remote access and
online weather information
System Desc
3. A pop-up screen asking if the email address below is
correct? Verify the email address is correct and press yes.
4. Another pop-up screen will appear notifying the user to
check their email.
An email has been sent to
xxxxxxxxxx@lennoxind.com
with instructions on how to register your thermostat. If you haven't
received the email, please check your spam folder and make sure
that your email address is correct.
NOTE - If the email address originally entered is incorrect,
return to the thermostat registered screen and reenter the
correct information and press register.
5. After the iComfort Wi-Fi
®
server sends the email with the
network link, registration and account creation must be
completed on the homeowners personal computer (see
Page 28).
NOTE - Time from pushing the registration button on the
thermostat and receiving the consumer portal register link
from your email on your computer is normally from 5 to 15
minutes.
6. After registration has been completed, press the
connection status icon to verify the connection was
successful. If the connection is successful the server icon
background will be green.
7. After successful connection to the server is completed,
the firmware update button will appear. The default setting
is set to auto. If any firmware updates are available they
will immediately start downloading and update the
thermostat. The thermostat will reboot itself after the
update is completed.
This auto update feature can be disabled by pressing the
firmware update button to toggle to OFF but is not
recommended.
NOTE - Firmware updates will not affect installer or user
thermostat settings. Both will be retained after the update.
WI-FI SETTINGS
connected
Wi-Fi
enabled
thermostat
registered
Connection to server has not bee established or it has been lost.
Please wait until a connection is established.
firmware
update
auto
press to enable /
disable Wi-Fi
press to change
wireless network
press to change
thermostat
registration
press to search
for new update
NOTE -
If any downloads are available for the thermostat they will start downloading
right away. When new firmware is being downloaded or when Gelaskins are
being installed, the thermostat screen will temporarily go blank and running
units may cease operation while the system is being reset to accommodate
the new changes. This is normal and can last a couple minutes.
AP3
connection
status
press to see
connection status
Figure 32. Registration for Online Access
To Next Page
Loading...
