16. Diagnostics
Page 65
PRODIGYT M2 UNIT CONTROLLER
ActionDisplay MessageCode
98
ALARM(98) CONTROLLER PROB-
LEM
INTERNAL CONTROLLER PROBLEM. RESET TO CLEAR.
99
ALARM(99) OUTDOOR ECON SEN-
SOR A24
CHECK SENSOR AND WIRING
100
ALARM(100) AIR VOL CONTROL
SETUP ERROR
CHECK FOR PROPER INSTALLATION OF GP BOARD AND SETTINGS
101
ALARM(101) MGV CONTROL SETUP
ERROR
CHECK FOR PROPER INSTALLATION OF GP BOARD AND SETTINGS
102
ALARM(102) GP CONTROL SETUP
ERROR
CHECK FOR PROPER INSTALLATION OF GP BOARD AND SETTINGS
103
ALARM(103) ADVANCED CONTROL
SETUP ERROR
CHECK PRODIGY SETTINGS
104 Reserved
105
ALARM(105) ADVANCED ECON
CONTROL SETUP ERROR
CHECK ECON SWITCHES, DIALS, AND PRODIGY SETTINGS
106
ALARM(106) BUILDING PRESS SEN-
SOR A34
CHECK SENSOR AND WIRING
107
ALARM(107) DUCT SUPPLY PRESS
SENSOR A30
CHECK SENSOR AND WIRING
108
ALARM(108) DUCT SUPPLY HIGH
PRESS SENSOR A30
CHECK SENSOR AND WIRING
109
ALARM(109) STRIKE 3 DUCT SUP-
PLY PRESS SENSOR A30
CHECK SENSOR AND WIRING
110
ALARM(110) WAITING ON NET-
WORK DATA
CHECK NETWORK OR COMFORT SENSOR AND WIRING
111
ALARM(111) CONTROLLER PROB-
LEM
INTERNAL CONTROLLER PROBLEM. RESET TO CLEAR.
112
ALARM(112) CONTROLLER PROB-
LEM
INTERNAL CONTROLLER PROBLEM. RESET TO CLEAR.
113 Reserved
114
ALARM(114) CONTROLLER PROB-
LEM
POWER NOISE PROBLEM. RESET TO CLEAR.
115
ALARM(115) UNIT OFFLINE FOR
TEST
CHECK PRODIGY SERVICE TEST MODE
116 Reserved
117 Reserved
118 ALARM(118) NO DISPLAY DISPLAY NOT DETECTED
119
STATUS(119) RESET CAUSED BY
WATCHDOG TIMEOUT
CONTACT LENNOX
120
ALARM(120) ADD−ON BOARD MCB
PROBLEM
MCB CONFIGURATION SETUP PROBLEM. RESET TO CLEAR OR AD-
VANCED SETUP.
121
ALARM(121) LINE FREQ DOES NOT
MATCH UNIT CONFIG
122
ALARM(122) 24VAC PRIMARY VOLT-
AGE LOW
123
ALARM(123) 24VAC PRIMARY VOLT-
AGE HIGH
124
ALARM(124) 24VAC SECONDARY
VOLTAGE LOW
125
ALARM(125) 24VAC SECONDARY
VOLTAGE HIGH
126
ALARM(126) LINE PHASING DOES
NOT MATCH UNIT CONFIG
127 Reserved
128 ALARM(128) 24VAC POWER LOSS
129 Reserved
To Next Page
Loading...
Need help?
General
