x16 PCIe riser assembly
Figure 21. x16 PCIe riser assembly
Table 12. x16 PCIe riser assembly
1 Slot 2, PCIe 3 x16, Full height, half-length
x8/x8 Butterfly riser assembly
Figure 22. x8/x8 Butterfly riser assembly
Table 13. x8/x8 Butterfly riser assembly
1 Slot 1, PCIe 3 x8, low profile 2 Slot 2, PCIe 3 x8, full-height, half-length
Internal cable routing
Some of the components in the server have internal cables and cable connectors.
Note: Disengage all latches, release tabs, or locks on cable connectors when you disconnect cables from
the system board. Failing to release them before removing the cables will damage the cable sockets on the
system board, which are fragile. Any damage to the cable sockets might require replacing the system board.
Some options, such as RAID controllers, might require additional internal cabling. See the documentation
that is provided for the option to determine any additional cabling requirements and instructions.
Chapter 2. Server components 23
To Next Page
Loading...
