A video of this procedure is available at YouTube: https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Step 1. Slide the drive into the drive bay. Make sure the drive handle is in the open position.
Step 2. Close the drive tray handle to lock the drive in place.
Figure 72. 2.5-inch hot-swap drive installation
Figure 73. 3.5-inch hot-swap drive installation
After you install all hot-swap drives, complete the following steps:
1. If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
2. Reconnect power cords and all external cables.
Install the server in a rack
To install the server in a rack, follow the instructions that are provided below.
To install the server in a rack, follow the instructions that are provided in the Rail Installation Kit for the rails
on which the server will be installed.
Cable the server
Attach all external cables to the server. Typically, you will need to connect the server to a power source, to
the data network, and to storage. In addition, you will need to connect the server to the management
network.
Connect to power
Connect the server to power.
Chapter 3. Server hardware setup 79
To Next Page
Loading...
