Note: Beware of that the FRU part number might change, please contact your Lenovo
representative or reseller for detailed information.
After you install the RAID adapter, complete the following steps:
1. Install the top cover onto the server (see “Install the top cover” on page 75).
2. Reinstall the power supply 1 if the redundant power supply model is used (see “Install a hot-swap power
supply unit” on page 76).
3. Install the server into the rack if necessary.
4. Reconnect power cords and all external cables.
5. Configure the RAID array using the Setup utility configuration.
Install an adapter
Use this information to install an adapter.
Before you install an adapter, complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Notes:
1. PCIe slot 1 and slot 2 do not support ARI and SR-IOV.
2. PCIe slot 3 supports ARI and SR-IOV.
3. QLogic QL41262 PCIe 25Gb 2-Port SFP28 Ethernet Adapter does not support shared storage V3700
V2/XP and V5030 V2 configurations.
To install an adapter, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Figure 48. Adapter installation
Step 1. Remove the fillers on the rear side of the riser cage.
Chapter 3. Server hardware setup 59
To Next Page
Loading...
