Ten 2.5-inch hot-swap drive model (two NVMe drives supported)
Figure 36. Ten 2.5-inch hot-swap drive model (two NVMe drives supported)
Table 28. Ten 2.5-inch hot-swap drive model (two NVMe drives supported)
1 Backplane power connector
2 RAID adapter connector(s)
• Connect to RAID x30 adapter: C0,
C1
• Connect to RAID x40 adapter: C0
3 NVMe switch card connectors: C0,
C1
Parts list
Use the parts list to identify each of the components that are available for your server.
For more information about ordering the parts shown in the Figure 37 “Server components - 2.5-inch drive
model” on page 39:
http://datacentersupport.lenovo.com/us/en/products/servers/thinksystem/sr250/7Y51/parts
Note: Depending on the model, your server might look slightly different from the illustration.
Chapter 2. Server components 37
To Next Page
Loading...
