S035
CAUTION:
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage,
current, and energy levels are present inside any component that has this label attached. There are no
serviceable parts inside these components. If you suspect a problem with one of these parts, contact
a service technician.
Before you install a hot-swap power supply unit, complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
To install a hot-swap power supply unit, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Figure 70. Hot-swap power supply unit installation
Step 1. Remove the power supply filler if necessary.
Step 2. Slide the hot-swap power supply unit into the bay until it snaps into position.
After you install a hot-swap power supply unit, complete the following steps:
1. Install the server into the rack if necessary.
2. Reconnect power cords and all external cables.
Install a simple-swap drive
Use this information to install a simple-swap drive.
Chapter 3. Server hardware setup 77
To Next Page
Loading...
