Lenovo ThinkSystem SR250 - Install the Front Operator Panel (2.5-Inch HDD Model)

2. Reinstall all the drives and drive fillers into the drive bays (see “Install a hot-swap drive” on page 78).
3. Install the top cover onto the server (see “Install the top cover” on page 75).
4. Install the server into the rack if necessary.
5. Reconnect power cords and all external cables.
Install the front operator panel (2.5-inch HDD model)
Use this information to install the front operator panel (2.5-inch HDD model).
Before you install the front operator panel (2.5-inch HDD model), complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
To install the front operator panel (2.5-inch HDD model), complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Step 1. Slide the front operator panel into the assembly bay.
Figure 61. Front operator panel (2.5-inch HDD model) installation
Step 2. Install the two screws to secure the front operator panel.
Figure 62. Screws installation
70 ThinkSystem SR250 Setup Guide