Figure 41. Air baffle removal
Step 1. Lift the air baffle up and set it aside.
Attention: For proper cooling and airflow, reinstall the air baffle before you turn on the server.
Operating the server with the air baffle removed might damage server components.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Remove the front operator panel (2.5-inch HDD model)
Use this information to remove the front operator panel (2.5-inch HDD model).
Before you remove the front operator panel (2.5-inch HDD model), complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 80).
3. If server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see “Remove the top cover” on page 52).
To remove the front operator panel (2.5-inch HDD model), complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Step 1. Disconnect the front operator panel cables from the system board.
54
ThinkSystem SR250 Setup Guide
To Next Page
Loading...
