Lenovo ThinkSystem SR250 - Install the Air Baffle

Figure 67. VGA cable installation
After you install the VGA cable, complete the following steps:
1. Reinstall the air baffle if it was removed (see “Install the air baffle” on page 74).
2. Install the top cover onto the server (see “Install the top cover” on page 75).
3. Install the server into the rack if necessary.
4. Reconnect power cords and all external cables.
Install the air baffle
Use this information to install the air baffle.
Before you install the air baffle, complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
To install the air baffle, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Figure 68. Air baffle installation
74 ThinkSystem SR250 Setup Guide