Figure 40. Top cover removal
Step 1. Press on the release button and the push point at the same time; then, slide the cover toward the
rear of the server.
Step 2. Lift the top cover away from the server.
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Remove the air baffle
Use this information to remove the air baffle.
Before you remove the air baffle, complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• “Installation Guidelines” on page 48
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 80).
3. If server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see “Remove the top cover” on page 52).
To remove the air baffle, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Chapter 3. Server hardware setup 53
To Next Page
Loading...
