Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Figure 59. 2.5-inch hot-swap drive backplane installation
Table 34. Pin in the chassis
1 Pin
2 Corresponding holes
Figure 60. 3.5-inch hot-swap drive backplane installation
Table 35. Pin in the chassis
1 Pin
2 Corresponding holes
Step 1. Align the two pins on the backplane with the corresponding holes in the chassis.
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
After you install the hot-swap drive backplane, complete the following steps:
1. Connect the backplane cables to the backplane. See “Internal cable routing” on page 23 for more
information.
Chapter 3. Server hardware setup 69
To Next Page
Loading...
