Figure 49. PCIe riser card installation
Step 2. Attach the label to the front side of the PCIe riser assembly.
Figure 50. PCIe riser assembly installation
Step 3. Align the two tabs on PCIe riser assembly with the slots on the rear chassis; then, insert the PCIe
riser assembly into the connector on the system board.
Figure 51. PCIe riser assembly installation
Step 4. Carefully press the riser assembly straight down into the slot until it is fully seated.
After you install the PCIe riser assembly, complete the following steps:
Chapter 3. Server hardware setup 61
To Next Page
Loading...
