Table 32. M.2 drive location
1 Screw for 80 mm M.2 drive (requires a#1 Phillips and
Hex 4.5 mm screwdriver)
3 M.2 connector
2 Screw for 42 mm M.2 drive (requires a #1 Phillips and
Hex 4.5 mm screwdriver)
Note: When you install the 80 mm or the 42 mm M.2 drive, you need to change the hex screw location
accordingly as the following illustration.
Figure 53. Hex screw location for 80 mm/42 mm M.2 drive
To install the M.2 drive, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/channel/
UCjqE4XzuvdHpVM9lXt41M8g/playlists
.
Figure 54. M.2 drive installation
Step 1. Insert the M.2 drive at an angle to the connector.
Step 2. Lower down the other side of the M.2 drive to the system board as shown.
Step 3. Fasten the screw to secure the M.2 drive.
After you install the M.2 drive, complete the following steps:
Chapter 3. Server hardware setup 63
To Next Page
Loading...
