Table 1. Server Specifications (continued)
Specification
Description
M.2 drive
Supports 2 different physical sizes of M.2 drives:
• 42 mm (2242)
• 80 mm (2280)
Notes:
1. When the eighth SATA drive is installed, the M.2 drive is disabled.
2. If the M.2 drive has been installed, and the system has been set to software
RAID mode in the UEFI settings, regardless if the disks are configured as an
array or as separate disks, the M.2 drive cannot be used to install the Windows
operating system.
PCIe riser cards and
expansion slots
Up to two expansion slots (depending on the server configuration):
• Slot 1-2: PCI Express 3.0 for PCIe -card with the following slots available
depending on the card installed:
1. x16 PCIe (full-height, half-length) kit provides:
– Slot 1: Not available
– Slot 2: PCI Express 3.0 x16
2. x8/x8 butterfly card:
– Slot 1: PCI Express 3.0 x8 (x8, x4, x1), low profile
– Slot 2: PCI Express 3.0 x8 (x8, x4, x1), full-height, half-length
• Slot 3 (on-board): PCI Express 3.0 x8 (x4, x1), low-profile
Notes:
1. PCIe slot 1 and slot 2 do not support ARI and SR-IOV.
2. PCIe slot 3 supports ARI and SR-IOV.
3. QLogic QL41262 PCIe 25Gb 2-Port SFP28 Ethernet Adapter does not support
shared storage V3700 V2/XP and V5030 V2 configurations.
Integrated functions
• Lenovo XClarity Controller, which provides service processor control and
monitoring functions, video controller, and remote keyboard, video, mouse, and
remote drive capabilities.
• Light-path diagnostics
• Front standard connectors (front of server):
– One USB 2.0 connector
– One USB 3.1 Gen 1 connector
– One front operator panel
– One VGA connector (optional)
• Rear standard connectors (rear of server):
– Two USB 3.1 Gen 2 connectors
– Two Ethernet connectors
– One Lenovo XClarity Controller network connector
– One VGA connector
– One serial connector
Chapter 1. Introduction 5
To Next Page
Loading...
