Figure 100. Routing USB 3.0 cable
1 USB 3.0 connector
2. Install the PCIe expansion tray (see “Install the PCIe expansion tray” on page 151).
3. Install the top cover (see “Install the top cover” on page 148).
4. Reconnect the power cords and any cables that you removed.
5. If the server is installed in a rack, reinstall the server into the rack.
6. Power on the server and any peripheral devices.
Remove an adapter
Use this procedure to remove an adapter.
Follow the following instructions accordingly to the location where the adapter has been installed.
Before removing an adapter from the system board or from PCIe riser card assembly:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
“Power off the server” on page 10).
102
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
