a. Install the 2.5-inch storage drive with a storage-drive converter into the storage-drive converter. Then
install the four screws to secure the new storage drive to the storage-drive converter.
Figure 105. Installing the 2.5-inch storage drive into the storage-drive converter
b. To install a new storage drive into the bracket, flex the bracket and align pin 1 , pin 2 , pin 3 , and pin
4 on the bracket with the corresponding holes in the storage drive. Do not touch the circuit board 5
on the storage drive.
Figure 106. Installing the 2.5-inch storage drive into the bracket
146 P330 Hardware Maintenance Manual
To Next Page
Loading...
