LENVII E688 - Chapter 3 Input;Output Settings

LENVII
22 www.lenvii.net
Chapter 3 Input/Output Settings
Introduction
This chapter mainly introduces the configuration of the beep and LED of
the barcode scanner when it is powered on, decoded, and triggered by
the button.
Startup Beeper
The scanner can be programmed to beep when it’s started up. Default =
Startup Beeper On.
(8410130.)
Startup Beeper Off
（8410131.)
* Startup Beeper On
Trigger Click Beeper
To hear an audible click every time the scanner button is pressed, scan
the Trigger Click Beeper On barcode below. Default = Trigger Click
Beeper Off.
(8410140.)
*Trigger Click Beeper Off
(8410141.)
Trigger Click Beeper On