LENVII
31 www.lenvii.net
Keyboard Operation
Different operations can be performed on the keyboard through
configuration during decoding output, such as automatic saving after
decoding output.
Step 1: determine the hexadecimal value corresponding to the keyboard
operation to be performed from the ASCII conversion of keyboard
operation, and Determine the 2-digit hexadecimal value of the barcode to
be set
Step 2. scan the barcode of "add keyboard operation".
Step 3. Determine the sequence of keyboard operation and barcode
output. If keyboard operation is in front, scan "add prefix" barcode, and
then scan "add suffix" barcode.
Step 4. Scan the corresponding 4-digit hexadecimal values in the
Programming Charts of this manual according to the corresponding
hexadecimal values (including barcode type and corresponding keyboard
operation)
Step 5. Scan "save" barcode.
Step 6, scan "end adding keyboard operation"
（8210042）
Add keyboard operation
（8210040）
End adding keyboard operation
Example: add operation that automatic preservation after decoding output
for all kinds of barcodes
First, confirm the operation to be performed: save after barcode output, so
suffix should be added after output barcode. Then determine the
corresponding hexadecimal value according to the table in the appendix,all
kinds of barcodes correspond to “9”“9”，The save operation corresponds
to “1”“3”。
After confirmation, scan "add keyboard operation" barcode, add suffix
barcode, 9, 9, 1, 3, and then scan "save" barcode and “end adding
keyboard operation” barcode
(Here "9" and "9" correspond to all coding systems, and "1" and "3"
correspond to decoding output and saving)
To Next Page
Loading...
