LENVII
27 www.lenvii.net
Chapter 4 Data Editing
Introduction
This chapter describes how to add prefixes and suffixes.
•
Default prefix = None. Default suffix = None.
•
A prefix or suffix may be added or cleared from one symbology or all
symbologies.
•
You can add any prefix or suffix from the ASCII Conversion Chart deplus
Code I.D. and AIM I.D.
•
Enter prefixes and suffixes in the order in which you want them to appear
on the output.
•
When setting up for specific symbologies (as opposed to all
symbologies), the specific symbology ID value counts as an added prefix or
suffix character.
•
The maximum size of a prefix or suffix configuration is 200 characters,
which includes header information.
To Next Page
Loading...
