Lenze 8200 vector - Page 154

Fault detection and elimination
Fault messages
8
EDK82EV113 DE/EN/FR 8.1
153
L
Error messages at the keypad or in the parameter setting program Global Drive
Control
Keypad PC
1)
Error Cause Remedy
noer
0 No fault − −
ccr

71 System fault
Strong interferences on control cables Shield control cables
Ground or earth loops in the wiring
ce0

61 Communication fault to
AIF
(configurable in C0126)
Faulty transmission of control
commands via AIF
Insert the communication module into the
hand terminal
ce1

62 Communication fault to
CAN−IN1 with Sync
control
CAN−IN1 object receives faulty data or
communication is interrupted
l Plug−in connection − bus module ó
Check FIF
l Check transmitter
l Increase monitoring time under C0357/1
if necessary
ce2

63 Communication error to
CAN−IN2
CAN−IN2 object receives faulty data or
communication is interrupted
l Plug−in connection − bus module ó
Check FIF
l Check transmitter
l Increase monitoring time under C0357/2
if necessary
ce3

64 Communication error to
CAN−IN1 with event or
time control
CAN−IN1 object receives faulty data or
communication is interrupted
l Plug−in connection − bus module ó
Check FIF
l Check transmitter
l Increase monitoring time under C0357/3
if necessary
ce4

65 BUS−OFF
(many communication
faults occurred)
Controller has received too many
incorrect telegrams via the system
bus and has been disconnected
l Check whether bus terminator available
l Check screen contact of the cables
l Check PE connection
l Check bus load, if necessary, reduce the
baud rate
ce5

66 CAN Time−Out
(configurable in C0126)
For remote parameter setting via
system bus (C0370):
Slave does not answer.
Communication monitoring time
exceeded.
l Check system bus wiring
l Check system bus configuration
For operation with module in FIF:
Internal fault
Contact Lenze
ce6

67 Function module
system bus (CAN) on
FIF has set "Warning"
or "BUS−OFF"
(configurable in C0126)
CAN controller sets "Warning" or "BUS
OFF"
l Check whether bus terminator available
l Check screen contact of the cables
l Check PE connection
l Check bus load, if necessary, reduce the
baud rate
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com