Lenze 8200 - Paramter setting; Setting adjustment

Parameter setting / Setting adjustment

19
MA8200MOT DE/EN/FR 3.0
How to change the setting of the user menu codes
Action Keys Display Note Example
1. Plug in the
keypad
g
VVVV
Hz
The function g is active = First code in the
user menu (C0517/1).
2. Inhibit
controller
s dc
Only necessary if you want to transfer parameter
sets (C0002).
3.
Set
t
wx f
Reduce C0012
(
l
t
i
4.
S
e
t
parameters
z ;;;;
Select code

R
e
d
u
c
e
C
0
0
1
2
(acceleration
t
i
m
e
)
f
r
o
m
5
0
0
s
5.
x k

For codes without subcodes: Jump immediately
to
i
time
)
f
r
om 5.00 s
to 1.00 s.
6.
yz ;;;
Select subcode
7.
x i  s
8.
yz ;;;;;
Set parameters
 s
9.
v 672 F Acknowledge entry if p blinking
9
.
w Acknowledge entry if p not blinking; v is not
active
10. Resta rt the ”loop” at 3. to set other parameters.
How to change the setting of the menu “ALL- codes
Action Keys Display Note
1.
Change to
t
h
e
m
e
n
t

Change to function bar 2
2.
g
the menu
”
A
L
L
”
wx o
3.
”
A
L
L
”
yz DMM
Select menu ”ALL” (list of all codes)
4.
t
å
Acknowledge selection and change to function bar 1
5. Inhibit
controller
s dc
Only required if C0002, C0148, C0174 and/or C0469 are to be changed
6. Set parameters As described for the user menu from step 3
Change parameter set
In order to change codes in one of the four parameter sets, select the parameter set required using the keypad.
Observe that some code settings are the same for all parameter sets. These codes are marked with a “*”.
Action Keys Display Note
1.
Select
f
n
c
t
i
o
n
t

Change to function bar 2
2.
function
wx m
Select function “Parameter set selection”
3.
Select
p
a
r
a
m
e
t
e
r
yz   
Select parameter set for change
4.
pa
r
amete
r
set
t
å
Acknowledge selection and change to function bar 1
5. Set
parameters
As described for the user menu on this page from step 3 ...
Note!
l The keypad can only be used to select the parameters sets and change the code settings.
Use digital signals (configuration under C0410 or C0007) to activate a parameter set for
operation!
l Function g displays the parameter set active in operation.
l All other functions display the parameter set active for being changed.
Show/Hide Bookmarks