Electrical installation
Control terminals
Important notes
6
73
EDS84ABD302 EN 4.0
Strip cables
Strip the control cables (analog and digital) according to the dimensions given i n the
following table.
X1 X4
84MOTL_BLC 84MOTL005
X1 X4
[mm
2
]
[AWG]
[mm
2
]
[AWG]
[Nm]
[lb-in]
E84AVBxE2512
0.2 ... 1.5
24 ... 16
0.2 ... 1.5
24 ... 16
0.5
4.5
E84AVBxE371x
E84AVBxE551x
E84AVBxE751x
E84AVBxE112x
E84AVBxE152x
E84AVBxE222x
E84AVBxE3024
Shield and connect cables
To shield the stripped control cables:
1. Form the cable’s braided shield into a pigtail.
2. Use a wire end ferrule for more stability (optional).
3. Insert the pigtail into one of the screw terminals on X13.
4. Use a suitable screwdriver (see illustration).
X4 X13
84BLGGX004 84BLGGX013
Fig. 6-15 Shielding and connecting control cables
To Next Page
Loading...
