Lenze 8400 motec - Motor control (MCTRL)

Parameter data transfer
CTT2: Acyclic device error codes
52
Lenze · Decentralised frequency inverter 8400 motec (AS-Interface option) · EDS84DMOTASI EN 4.0 - 09/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
9.7 CTT2: Acyclic device error codes
Error code [hex] Description
Byte 0
(MSB)
Byte 1 Byte 2 Byte 3
(LSB)
0x00 0x00 0x00 0x00 Transfer aborted
0x06 0x03 0x00 0x00 • No access rights
• Invalid access
• Read-only object
0x06 0x05 0x00 0x10 Invalid service
0x06 0x05 0x00 0x11 Invalid subindex
0x06 0x05 0x00 0x12 Data length too large
0x06 0x05 0x00 0x13 Data length too small
0x06 0x06 0x00 0x00 Object is no parameter
0x06 0x07 0x00 0x00 Object does not exist
0x06 0x08 0x00 0x00 Data (types) do not correspond
0x08 0x00 0x00 0x00 • Invalid function
• Request cannot be executed
•No operation
0x08 0x00 0x00 0x20 Request cannot be executed at the moment
0x08 0x00 0x00 0x21 No operation due to local control
0x08 0x00 0x00 0x22 Request cannot be executed due to the device state
0x08 0x00 0x00 0x30 • Value beyond the range
• Parameter can only be changed when the controller is inhibited
(CINH)
0x08 0x00 0x00 0x31 Parameter value too high
0x08 0x00 0x00 0x32 Parameter value too low
0x08 0x00 0x00 0x33 Value range of the (sub)parameter exceeded
0x08 0x00 0x00 0x34 Value range of the (sub)parameter too high
0x08 0x00 0x00 0x35 Value range of the (sub)parameter too low
0x08 0x00 0x00 0x36 Maximum value lower than minimum value
0x08 0x00 0x00 0x41 Communication object cannot be displayed
0x08 0x00 0x00 0x42 Process data length exceeded
0x08 0x00 0x00 0x43 General value collision
0x08 0x00 0x00 0x50 • Block access has failed
• One or several parameter accesses within the block have failed
• Read exception list for more details
0x08 0x00 0x00 0x80 Hardware error