Lenze 8400 motec - Data Transmission Slave 1 (AS-I Profile 7.A.5)

Data transfer
Data transmission slave 1 (AS-i profile 7.A.5)
34
Lenze · Decentralised frequency inverter 8400 motec (AS-Interface option) · EDS84DMOTASI EN 4.0 - 09/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.5 Data transmission slave 1 (AS-i profile 7.A.5)
Accessing the data bits
Accessing the parameter bits
Bits Signal / I/O mapping Description / standard connection with ...
Inputs
DI0 DigIn_bIn2 The function of these inputs cannot be selected in the
»Engineer«.
Can be used to monitor the digital inputs if the Drive Unit is
in the "offline" status.
DI1 DigIn_bIn4
DI2 Serial Clock In Intended for CTT2 transmission.
DI3 Serial Data In
Outputs
DO0 Serial Clock Out Intended for CTT2 transmission.
DO1 Serial Data Out
DO2 LP_Network_In: MCI_bCtrl_B3 C00701/3: not connected
DO3 Reserved Reserved for AS-i A/B addressing
Bits Signal / I/O mapping Description
P0 Reserved Selection of the process image:
• 0: Data of the extended (cyclic) process image 1
• 1: Data of the extended (cyclic) process image 2
Extended process image for slave 1
( 35)
P1 Reserved
P2 Reserved
P3 Reserved Reserved for AS-i A/B addressing