Lenze 9400 Series

13 Error messages
13.1 Short overview of the EtherCAT error messages
92
Lenze · E94AYCET communication module (EtherCAT®) · Communication Manual · DMS 10.2 EN · 11/2018 · TD06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13 Error messages
This chapter supplements the error list in the reference manual and the »Engineer« online help for
the Servo Drive 9400 by the error messages of the E94AYCET (EtherCAT) communication module.
13.1 Short overview of the EtherCAT error messages
The following table lists all EtherCAT error messages in numerical order of the error number.
Furthermore the preset error response and – if available – the parameters for setting the error
response are specified.
 Tip!
If you click on the cross-reference in the first column, you will get a detailed description
(causes and remedies) of the corresponding error message.
 Reference manual/online help for the Servo Drive 9400
Here you will find general information on diagnostics & fault analysis and on error
messages.
Error number Name Response (Lenze setting) Adjustable in
hex dec
0x00c83100
13119744 EtherCAT: Connection to 9400 lost No response -
0x00c85114
13127956 EtherCAT: Internal supply voltage too low Information -
0x00c85531
13129009 EtherCAT: Memory: No access Information -
0x00c85532
13129010 EtherCAT: Memory: Error while reading Information -
0x00c85533
13129011 EtherCAT: Memory: Error while writing Information -
0x00c86010
13131792 EtherCAT: Restart after watchdog reset Fault -
0x00c86011
13131793 EtherCAT: Internal error Fault -
0x00c86100
13132032 EtherCAT: Internal error Information -
0x00c86101
13132033 EtherCAT: Internal error Fault -
0x00c86110
13132048 EtherCAT: Internal mapping error Warning Locked -
0x00c8641f
13132831 EtherCAT: Parameter set invalid Fault -
0x00c86420
13132832 EtherCAT: Error: Lenze setting loaded Fault -
0x00c86610
13133328 EtherCAT: Communication time-out with safety module
(from SW version 04.00)
Warning Locked
0x00c86612
13133330 EtherCAT: Initialisation error with safety module
(from SW version 04.00)
Warning Locked
0x00c88131
13140273 EtherCAT: Quit the 'Operational' status No response C13880/1 /
C14880/1
0x00c88132 13140274 EtherCAT: Sync loss detected in standard device Warning Locked -
0x00c88700
13141760 EtherCAT: Sync telegram failure No response C13880/2 /
C14880/2