Lenze E84DGFCG Series - Page 29

Commissioning
Configuring the host system (scanner)
29
Lenze · Decentralised frequency inverter 8400 motec (EtherNet/IP™ option) · EDS84DMOTEIP EN 2.0 - 10/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5. Go to the Port Configuration tab and enter the IP configuration, BOOTP setting, Ethernet
baud rate and duplex mode.
6. Then click OK.
• Now, the scanner is configured for the EtherNet/IP network.
• Here you will find information on project planning with the »RSLogix 5000«
programming software from Rockwell:
I/O configuration with »RSLogix 5000« version 19 or lower
( 57)
I/O configuration with »RSLogix 5000« version 20 or higher
( 62)