Lenze i550 Series - Application as Directed; Handling

Applicaon as directed
•
The product serves to control three-phase AC motors and servo motors.
•
The product must only be actuated with motors that are suitable for the operaon with inverters.
•
The product is not a household appliance, but is only designed as a component for commercial or
professional use in terms of EN 61000−3−2.
•
Depending on the degree of protecon, the product can be mounted inside and outside control cabinets.
•
The product must only be actuated under the operang condions and power limits specied in this
documentaon.
•
The product meets the protecon requirements of2014/35/EU: Low-Voltage Direcve.
•
The product is not a machine in terms of 2006/42/EU: Machinery Direcve, with the excepon of all
funcons of the funconal safety.
•
Commissioning or starng the operaon as directed of a machine with the product is not permied unl
it has been ensured that the machine meets the regulaons of the EC Direcve 2006/42/EU: Machinery
Direcve observe; EN 60204−1 .
•
Commissioning or starng operaon as directed is only permissible if the EMC Direcve 2014/30/EU is
complied with.
•
In residenal areas, the product may cause EMC interferences. The operator is responsible for taking
interference suppression measures.
The user is not allowed to change inverters that come with integrated safety technology.
The user must not carry out any repairs on the safety module.
The safety module is not a spare part.
The safety module must not be removed.
If the safety module is defecve, the inverter has to be replaced.
Handling
•
Never commission the product in the event of visible damage.
•
The product must never be technically modied.
•
Never commission the product before assembly has been completed.
•
The product must never be operated without required covers.
•
Establish, separate and change all electrical connecons only in deenergised state!
Safety instrucons
Handling
64