Lenze i550 Series - Ethercat

EtherCAT
Notes on the EtherCAT connecon status and the data transfer can be obtained via the LED "L/A" at the RJ45
sockets.
LED "L/A"
Blinking paern State Meaning
o Not connected Network not available
on
Connected Network available
No data transfer
blinking
Trac Data transfer
Typical topologies
Line
IN OUT
M
R
SDn
SD2
SD1
IN OUT IN
M Master
SD Slave Device
Bus-related informaon
Name EtherCAT
Communicaon medium Ethernet 100 Mbps, full duplex
Use Connected as EtherCAT slave
Status display 2 LEDs (RUN, ERR)
Basic network sengs
The rotary encoder switch allows you to set an EtherCAT idener.
x16 x1
Seng Idener
0x00 Value from parameter
0x01 ... 0xFF Switch posion
Electrical installaon
Networks
EtherCAT
90