Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17 39
6 Commissioning
6.4 Setting the IP configuration
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. By double-clicking on the individual IP parameters, you can set the IP configuration for each
PROFINET node in the 'Configure nodes' dialog window.
3. Click the Transferred button.
• The IP configuration is transferred to the corresponding PROFINET node.
• Changes in the IP parameters will become effective immediately.
• The IP parameters are written to codes C13000
/ C14000 (IP address), C13001 / C14001
(subnet mask) and C13002
/ C14002 (gateway address).
Tip!
By clicking the Find device in the 'Assign IP addresses' dialog window (see step 1) you can
check whether the configuration has been transferred successfully.
With device command C00002 = "11: Save start parameters" , the current IP configuration
is saved non-volatilely in the memory module.
To Next Page
Loading...
