Lenze PROFINET 9400

1 About this documentation
1.3 Terminology used
8
Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Inverter Lenze inverters of the "Servo Drives 9400" product series
Standard device
Code Parameter that serves to parameterise and monitor the inverter. This term is
usually referred to as "index" in common parlance.
Subcode If a code contains several parameters, they are stored in "subcodes".
In the documentation, the slash "/" is used as a separator between the code and
the subcode (e.g. "C00118/3").
The term is also referred to as "subindex" in common parlance.
»Engineer« Lenze PC software which supports you during the "Engineering" process
(parameterisation, diagnostics, and configuration) throughout the whole life
cycle, i. e. from planning to maintenance of the machine commissioned.
FW Firmware
HW Hardware
I/O controller PROFINET master
The I/O controller takes over the master function for data communication of the
decentralised field devices. The I/O controller usually is the communication
interface of a PLC.
I/O device PROFINET slave
IO supervisor Engineering and diagnostics tools
The IO supervisor can access process data, diagnostic data, and alarm data.
IOPS (IO Provider State) Status of the process data sent by the IO controller
• A "GOOD" status indicates that the process data sent are valid.
• A "BAD" status indicates that the process data sent are invalid.
Lenze setting Default settings of the device, preconfigured ex works.
Basic setting
PROFINET® (Process Field Network) is a real-time capable fieldbus system based
on Ethernet.
PROFINET® is a registered trademark and patented technology licensed by the
PROFIBUS & PROFINET International (PI) user organisation.
PROFIsafe The certified safety protocol for the transmission of safety-oriented data via
PROFINET
»STEP7« / »HW Konfig« Siemens PC software for PROFINET configuration
»Primary Setup Tool«
SW Software