Lenze SX-1 - 3. General Information; 3.0 Introduction

3. General Information
3.0 Introduction
The SX-1 Positioning System allows the precise positioning of workpiece, tool or material,
with optimum control of speed and acceleration. Multi-axis Systems may be configured
using a personal computer, by interconnecting SX-1 units using the I/O facilities built in.
Alternatively, axes may be co-ordinated by using a Programmable Logic Gontroller (PLC).
4 lncremental or Absolute
Encoder
5 Motor
6 Gearbox or Coupling
7 Drive Shaft
8 Workpiece, Tool
or Material
3/0
Axis Controller SX-1, with
interface connectors X1-X4
(See chpt. 3.1.1)
Terminal PT-1,
PC
3 Servo Controller
EZD~
DDDDDD
Lanze