Lenze SX-1 - 8.7 Central Archiving of Programs and Parameters; 8.8 Axis Identification; 8.9 Software Identification

8.7 ____
8.7 Central Archiving of Programs and Parameters
Programs and Parameters may be archived using the data communications link Softwa -
re packages are available tor the Siemens PG 675 and 685, and IBM AT and XT.
Please enquire tor turther intormation.
8.8 Axis ldentification
When the SX-1 is Switched On or Reset, an Axis ldentification number is displayed.
Example: Sequential display of
A = Axis~
0
0
8.9 Software ldentification
When the SX-1 is Switched On or Reset, a Software ldentitication number is displayed
after the Axis ldentification.
Example:
Software ldentification e. g. Release 5.10
Pause
Axis ldentitication
8/36
Lanze