Lenze SX-1 - 7.3 Changing Parameters; Valid Entry Check

7.3 Changing Parameters
1. Firstly, you must select PARAMETER mode (see Chapter 7.2).
2. Load the parameters to be changed trom the SX-1 into the PT-1 usirig the LOAD
key. This copies the parameters trom the SX-1 into the PT-1 memory.
3. Change and Edit the parameters as described in Chapter 7.2.
4. Remember to send the edited parameters back to the SX-l using the SAVE keyl
NOTE!
Whilst Saving, a certain time is required for programming the EEPROM.
:0‘...
1. The MODE key is used to commence the entry ot values, and to select text
character groups.
1
2. An incorrect entry may be cleared using the CE key provided that the ENTER
key has not yet been pressed.
Valid Entry Check.
7/
The PT-1 checks the entered values for validity, exceeding permitted range,
etc, and reports when the conditions are not met when the ENTER key is
pressed, e. g. in the first line „>„ is displayed for „value too large“ or „c“ tor
„value too small“. At the same time, the invalid entry is deleted. lt is not possible ~
to finish entry of that Parameter until an acceptable value is entered.
7/32
Lanze