Lenze SX-1 - Save Parameters

7.2
The parameters are first stored in the memory otthe PT-l. Pressing the SAVE keytransmits
them into the EEPROM memory ot the SX-l tor preservation despite supply interruption.
Do not forget to do this!
The values may be sent even when a program is running, but they are not then used until
the program is stopped, because a short conversion routine must be performed. (The
position control is switched ott during this conversion, but the servo is still enabled, so a
small amount of drift may occur).
Save with:
E~i~
PT-1 requests which Axis the
to?
parameters belong
• lt the parameters belong to the Axis in
the first line, press ENTER.
After the process is completed, the para -
meter display re-appears.
• lt the parameters belong to a difterent
Axis, press MODE
Type in the Axis number and press ENT -
ER.
SAVE -> Axis ~
Paramters
Sendi ng
SAVE -> Axis
o.k. = <ENTER>
Axis? = <MODE>
The number in the first line disappears.
7/31
Lanze
SAVE -> Axis £J~
o.k. = <ENTER>
Axis? = <MODE>