Lenze SX-1 - 6.2 Modes of Operation - Software Version 4.XX; Selecting Operating Mode

6.2
6.2 Modes of Operation - Software Version 4.XX
(For a general description of operation, see Chpt. 4)
You must state that Software Version 4.XX is required when ordering.
Operating Modes
1. Remote:
Selection of Manual-Remote or Automatic-Remote from the PT-1 terminal.
2. External:
Selection of Manual-External or Automatic-External Mode via inputs E5 to E8.
Selecting ODerating Mode
Select Automatic and Remote modes in the order E8, E7, E6, E5; and you must select
manual modes in the order E5, E6, E7, E8, otherwise there will be malfunctionl
To de-select a mode, use the reverse order.
The following chart shows the state of input signals E5-E8 and the modes selected:
FMode E5
{E6tE7EB
Manual External 0
Displayof1
Jog Right ~‚ 1 0~ 0 0 —
Jog Right, Fast 1‘i 0 1 0
Jog Left 0 j‘1 0 0 —]
Jog Left, Fast 0H‘i 1
Home 0 0 ib> 0
Automatic External 1011
0 0 1
r fl 0
StartSingleStep(0—>1) 1 1~) 1 0 1
Stop Single Step 0 1 0 1 A
Start Continuous 1‘la> 0 0 1
StopContinuous o~o i
0~i~____ Remote Control d
a) Input ES is read dynamically tor the „start“ function, and statically tor the supervisory
function.
b) Homing is initiated by the 0-1 edge at E7, and E7 is monitored statically during the
homing cycle.
c) Input ES is monitored statically as the supervisory function.
___ ___— 6/6 — — -- —___
Lenze